
96
EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment
Miscellaneous Planning and Procedures
16. If there are other QLogic HBAs installed, repeat steps 5 through
16 until all adapters have been installed.
17. Reboot the host.
Updating the HBA driver in a Windows 2000 or Windows 2003 host
On Windows 2000 and Windows 2003 systems where the QLogic
HBA has been detected automatically or a driver is already installed,
it may be necessary to update the current driver to the latest
EMC-qualified driver, as described in this section.
The following procedure assumes that you have copied the latest
driver from the QLogic CD-ROM or downloaded it from the QLogic
website and put it onto a diskette. Refer to the release notes provided
with the driver for information that might be unique to new driver
revisions.
To install the driver into a Windows 2000 or Windows 2003 host:
1. Boot the host (if necessary) with Windows 2000 or Windows 2003.
2. From the Windows taskbar, click Start > Run, then type
Compmgmt.msc and press Enter.
3. In the left pane of the Computer Management window, click the
Device Manager icon.
4. Double-click the SCSI & RAID Controllers icon.
5. Under SCSI & RAID Controllers, double-click the adapter you
wish to upgrade.
6. In the next window, click the Driver tab; then click Update
Driver.
7. Follow the update wizard until you are given the choice to
Display a list of the unknown drivers for this device so that you
can choose a specific driver. Click the button next to this choice;
then click Next.
8. In the Select a Driver window, click Have Disk.
9. Enter the path to the diskette containing the driver (A:\, for
example), or use the browse function to locate the driver; then
click OK.
10. Select the driver that is discovered and click Next.
11. In the next window, click Next.
Comentarios a estos manuales