EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 88)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

This can be accomplished by the following procedure:

a. On POST when the QLogic HBA displays, press < Ctrl Q>

for Fast!Util.

b. Go to Configuration Settings > Host Adapter Settings.

c. Toggle down to Initiator iSCSI Name.

d. Press Enter on the name and type in the new name.

e. Press ESC twice to get to Save Settings.

f. Save the settings. This will force a login to the storage device.

3. Register the new iqn name and add it to your storage group on

the CLARiiON storage array.

Note: Only register one path. Ensure that the path is from the SP that the

lun belongs to. Failing to do so could result in a blue screen during the

installation process. You can also refer to CLARiiON documentation for a

more detailed procedure for setting up Storage Groups and Registering

host names.

4. On the host in the QLogic Fast!Util, go to the iSCSI Boot

Settings.

5. In Primary Boot Device press < Enter>.

This will bring you to the device list page.

6. Select the DGC device that displays the RAID level.

Ensure that the iSCSI Boot field on that page is set to Enabled.

7. Save all settings and reboot the host and load the Operating

System. Refer to “Installing the Windows operating system” on

page 52.

8. After the operating system is loaded and before the initiator

service is loaded, register the remaining paths on the CX storage

array.

9. Install the Initiator Service.

10. During the Microsoft Initiator installation, deselect the Software

Initiator. ONLY install the Initiator Service. This will attempt to

change the iqn name to fit the Microsoft naming convention.

Since this was done in step 2, it will not blue screen the host for an

inaccessible boot device.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 88