EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 100)

100

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

Stratus ftServers are not supported using the QLogic SANsurfer

SANblade Manager Software or Agents, and should only be updated

using the DOS boot diskette. Refer to “Install/upgrade firmware and

boot BIOS from DOS” on page 25 for this procedure.

Updating the flash BIOS using SANsurfer FC HBA Manager

Note: The SANSurfer FC HBA Manager flash BIOS update feature is

available only on Windows 2000/Windows2003.

WARNING

Changing flash BIOS incorrectly can cause serious damage to your

system.

Perform the following steps to update the flash BIOS:

1. In the SAN

SANSurfer FC HBA Manager main menu HBA tree,

select the adapter.

If you want to configure multiple adapters with the same settings,

hold the CTRL key while selecting multiple adapters. The

adapters must be in the same series:

QLA231x HBAs, QLA234x HBAs, or QLA22xx HBAs.

Note: Only the Settings (Adapter Settings and Advanced Adapter

Settings) and Utilities tabbed pages can be configured for multiple

adapters; therefore, the remaining tabbed pages do not display when

multiple adapters are selected.

2. Click the Utilities tab. The Utilities page displays (see Figure 63

on page 101).

Note: If you selected multiple adapters, the Save Flash and Save

NVRAM radio buttons do not display. These options cannot be

performed with multiple adapters. Some versions of SANsurfer may

have buttons referring to Option ROM. Option ROM and Flash both

refer to the HBA BIOS.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 100