EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 52)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

Installing the Windows operating system

This section is a step-by-step procedure for installing Windows

2000/2003 Operating System to either an internal or external boot

device.

After you have your HBA(s) installed in your server, and configured

for external boot if necessary, the next step is to install the Windows

operating system. If you intend to boot to an external device please

refer to “Booting from the external storage array” on page 24 for

setting the boot BIOS for external boot and selecting the external boot

lun. If your system is EFI-based refer to “Installing a RAMDISK

under the EFI shell” on page 50. Also refer to your server’s

documentation for preparing your server for external boot.

Note: If you intend to boot to an external disk, only present the LUN that you

intend to boot from. All additional luns can be added after the installation.

This will eliminate any confusion on selecting the correct partition for

installation and eliminates any problems that the Operating System could

encounter on reboot during the installation. Also confirm there is only one

path to the storage array. Having more than one path can cause the operating

system to fail during the installation.

You need the following materials to install Windows:

◆ A Windows CD-ROM for the Windows version you wish to

install

◆ AN EMC-approved HBA driver diskette for Windows, or an EFI

RAMDisk if it is an EFI based install

To install Windows:

1. Insert a bootable Windows CD-ROM in the drive and reboot the

system. If your system has a bootable disk already configured

from a previous installation, the software will prompt you to

press any key to boot from CD-ROM.

2. If you are installing Windows to boot from an external array disk,

you will need to supply setup with the HBA driver. To do this,

immediately after the Windows installation begins, press F6

when directed or when the blue screen appears. Otherwise,

proceed to step 6.

Pressing F6 tells the Windows installer you want to load a

third-party driver before proceeding with the installation.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 52