EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 44)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

7. Press Enter to access the file system containing the QLogic EFI

boot code.

• If the EFI boot code resides in a subdirectory, type cd

<subdirectory name> and press Enter.

8. Type efiutil to start the QLogic EFI Utility and press Enter.

• At this point, the QLogic HBA instances should be shown

with a specific firmware version, and "AUX" should not be

listed next to the firmware, as shown in Figure 26.

• At this point, the EFI drivers, firmware, and NVRAM settings

have loaded to the HBA(s).

Figure 26 QLogic HBA instances with specific firmware version

9. Type q and press Enter to exit the QLogic EFI Utility.

10. At the EFI shell prompt, type drivers and pressEnter. Note the

entries that reference "QLogic Fibre Channel Adapter" are similar

to the listing shown in Figure 27..

Figure 27 QLogic Fibre Channel drivers

11. Make note of the first two digits (referred to as the "driver

handle") on the line that references the "QLogic Fibre Channel

Driver". If multiple HBAs are installed in the server, there will be

multiple entries, as shown in Figure 27.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 44