EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 108)

108

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

The loop ID value entered here is the decimal representation of

the FC-AL loop ID. You do not need to perform any FC-AL

AL_PA hexadecimal translation.

HBAs connected to the same SP should all have unique hard loop IDs.

Select 0 for all HBAs on one node, select 1 for all HBAs on the next node,

and so on.

7. Enter a value for the loop ID and press Enter.

8. Press

Esc to return to the Configuration Settings menu.

9. Press

Esc to return to the Fast!UTIL Options menu.

10. When prompted to save changes made to the current adapter,

select Save Changes and press

ENTER.

11. If there are more adapters to configure, choose Select Host

Adapter, and repeat steps 3 through 11 for each adapter.

12. Press

Esc to exit Fast!UTIL.

13. Reboot the host.

14. Repeat this procedure on all nodes in the cluster connected to the

CX200-Series array.

15. While you are in the BIOS, you can verify that the topology is set

correctly for direct connect (FC-AL).

CAUTION

Future use of the firmware NVRAM file to apply settings will

overwrite and possibly invalidate the changes made above. If you

will later update using a firmware NVRAM file, be sure it is listed

and supports this CX200-Series direct-connect cluster

configuration.

Note: To restore EMC default HBA settings, either reload the approved EMC

NVRAM file, or return to step 5 and ensure Adapter Hard Loop ID is set to

Disabled.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 108