EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 38)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

• The file system you select depends upon what media contains

the QLogic EFI boot code/utility. In this example, the QLogic

EFI boot code/utility resides on the USB memory drive.

3. Point the EFI shell to the proper file system by typing fsN: (where

N is the number which references the proper file system) followed

by Enter.

4. Before loading the QLogic EFI boot code/driver to the HBA(s),

ensure that any old EFI boot code loaded in the system has been

removed. Type drivers at the EFI shell prompt and press Enter.

a. Look for any driver listings that reference "QLogic Fibre

Channel Adapter," similar to the listing shown in b.Figure 20

Figure 20 Reference to QLogic Fibre Channel driver

b. If such a driver entry exists in the output, it should be

removed before installing the current driver. Make note of the

first two digits on the line which references the QLogic Fibre

Channel Driver ("60" in the example shown in Figure 20); this

is the "driver handle". Type unload <driver handle>.

For the example shown in Figure 20, unload 60 would be used

to remove the EFI driver. The system will prompt to "Unload

Protocol Image (y/n)?". Type y and press Enter. The existing

QLogic EFI driver will now be removed.

5. Type dir and press Enter to list the contents of the directory. If the

directory contents are not consistent with what you expect, and

do not appear to contain the QLogic boot code/utility, the file

system select may be incorrect.

6. Verify the proper file system has been selected. If the QLogic boot

code/utility resides in a subdirectory, type cd subdirectory and

press Enter.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 38