EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 75)

Installing additional Navisphere Host Agent software

Installation and Configuration

Installing additional Navisphere Host Agent software

The Navisphere Host Agent should be used to automatically register

host connections with the array. PowerPath and ATF require different

registration types and the Navisphere Host Agent is the preferred

method over manual registrations.

You should install the Navisphere Host Agent software to ensure the

HBA connections are all registered correctly. For instructions on how

to perform this operation refer to the EMC ControlCenter Navisphere

Host Agent software documentation for your array type.

After the host agent has started and registered the new HBA paths,

you should refresh the host connections in the storage group to

ensure all available paths are assigned. To do this, you have two

options, depending on whether you want to disrupt the connectivity

of the host, as described next.

Option 1: Without disrupting host connectivity (more complex

procedure using Navisphere CLI):

Note: You must have Navisphere CLI installed. Refer to product notes for

complete usage instructions.

1. Using a command prompt, browse to the Navisphere CLI

directory (typically C:\Program Files\EMC\Navisphere CLI>.

2. Enter command

navicli -h <sp_IP> storagegroup

-connecthost -host <hostname> -gname

where <sp_IP> is the IP address of either array SP; <hostname> is

the hostname of the host connection to update and

<storagegroupname> is the name of the storage group of the host

connection to update.

3. When prompted, verify the <hostname> and <storagegroupname>

are correct as follows:

Connect host <hostname> to storage group

<storagegroupname> (y/n)?"

Enter y to proceed.

4. Perform a device rescan on your host, and verify the additional

device paths are present.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 75