EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 90)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

Setting up external boot for IBM BladeServer HS40 (8839)

This section contains the folloiwng information:

◆ “Configuring an HS40 BladeCenter server to boot from an

external array” on page 90

◆ “BladeServer restrictions” on page 91

Configuring an HS40 BladeCenter server to boot from an external array

IBM HS40 (8839) Bladeservers encounter a dual-port HBA conflict

when attempting to configure boot BIOS to boot from an external

array. To configure an HS40 BladeCenter server to boot successfully

follow the steps below.

1. Create a single zone containing the HBA port from which you

want to boot. This prevents any conflicts with the other fibre

port.

2. Configure the QLogic BIOS to boot from the EMC array as

described earlier in “QLogic QLA23xx-based FibreChannel HBA

BIOS/boot LUN settings” on page 26. During server POST, be

sure that the QLogic banner displays the selected boot LUN

correctly before continuing.

3. Reboot the host and press

F1 to enter the server BIOS

Configuration/Setup Utility.

4. Select Devices and I/O Portsand press Enter.

5. Select IDE Configuration Menu and press Enter

6. Select the Onboard PCI IDE Controller and press Enter. Under

the options menu, set this IDE Controller to disabled. This will

disable the internal IDE disk drives.

7. Press

ESC twice to return to the IDE Configuration Menu and

then select Start Options and press Enter.

8. Select Startup Sequence Options and press Enter.

9. Select Third Startup Device and press Enter.

10. Select HAx PortID xxxxxx xxxxx and press

Enter. This boot device

will be replaced as the Third Startup Device in the Startup

Sequence Options.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 90