EMC Qlogic QLA23xx Guía de instalación descargar pdf (Pagina 92)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

Manually installing the HBA driver – Advanced users

To use EMC storage array disks with a Windows host, you need an

EMC-qualified Fibre Channel HBA driver. The HBA kit includes an

EMC-approved driver, which must be installed and configured prior

to partitioning the storage array disks. You also should check the

QLogic website for the latest EMC-approved version. Refer to

“Downloading latest QLogic drivers/firmware/BIOS files” on

page 16.

These procedures are necessary if not using the SANsurfer HBA

Install Wizard. Refer to “Installing HBA driver and software utilities”

on page 60.

Driver revision

History Driver support is as follows:

◆ Version 8.1.5.20 – QLA22xx, QLA23xx (no CX200-Series

direct-connect dual host cluster), Windows 2000

◆ Version 8.1.5.21 – QLA23xx, Windows 2000

◆ Version 8.2.1.20 – QLA23xx, Windows 2000

◆ Version 8.2.2.20 – QLA23xx STORPort, Windows 2003 only

◆ Version 8.2.2.25 – QLA23xx, Windows 2000 and Windows 2003

◆ STORPort 8.2.3.26 and SCSIPort 8.2.3.21 – QL23xx, Windows 2003

(SCSI and STOR) and Windows 2000 (SCSI only)

◆ STORPort Version 8.2.3.27 – QLA23xx, Windows 2003 only

◆ STORPort 9.0.0.17 and SCSIPort 9.0.0.12 – QL23xx, Windows 2003

(SCSI and STOR) and Windows 2000 (SCSI only)

◆ STORPort 9.0.1.18 Stratus computers only and SCSIPort 9.0.0.12 –

QL23xx, Windows 2003 (SCSI and STOR) and Windows 2000

(SCSI only)

◆ STORPort 9.0.1.17 and SCSIPort 9.0.1.12 – QL23xx, Windows 2003

(SCSI and STOR) and Windows 2000 (SCSI only)

◆ STORPort 9.0.1.15 and SCSIPort 9.0.1.10 – Dell 2342M/2362M

embedded adapters, Windows 2003 (SCSI and STOR) and

Windows 2000 (SCSI only)

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 127 128

Sin comentarios

EMC Qlogic QLA23xx Guía de instalación Pagina 92