EMC Qlogic QLA22xx Guía de instalación descargar pdf (Pagina 89)

Installing and Configuring the QLA4010 iSCSI HBA to boot from an EMC Storage Array

4-15

Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)

2. After Fast!UTIL loads, the display depends on whether there are

multiple QLogic HBAs installed:

• If there is only one QLogic HBA, the Fast!UTIL Options menu

appears.

• If there are multiple QLogic HBAs, a list of addresses occupies

by those HBAs appears. Use the arrow keys to select the

desired HBA; then press

ENTER. The Fast!UTIL Options menu

appears.

3. Select Configuration Settings from the menu.

4. Select Host Adapter Settings, and enable Host Adapter BIOS.

5. Set the LUNs per target to 256.

6. Set the Initiator IP address (EMC does not currently support

DHCP for iSCSI HBAs.)

7. Set the subnet mask for the iSCSI HBA.

8. Set the network gateway IP address.

9. Select the Initiator iSCSI name, and press

ENTER. This will display

the complete IQN (iSCSI Qualified Name) for the iSCSI HBA.

This is similar to the WWN for a fibre-channel HBA. Make a note

of the IQN for LUN masking purposes if LUN masking is in use

on your storage array.

10. If you are using CHAP security for your iSCSI network, enter the

CHAP name and CHAP secret in the appropriate locations in the

setting menu.

If you are experiencing timing issues with boot LUN availability (refer to

Boot Time and LUN Availability on page 4-18), then enable the Spinup

Delay parameter.

11. Press ESC to return to the previous menu.

12. Select iSCSI Boot Settings.

13. Select iSCSI Boot, and set it to enabled.

14. Select Primary Boot Device Settings, and press

ENTER. Under the

Primary Boot Device Settings dialog that appears, enter the

security settings (if necessary), target (array port) IP address, and

the target port (default of 3260 is the default port number for

Symmetrix and CLARiiON iSCSI ports.) Boot LUN and iSCSI

Name can be left blank.

QLogic_Windows.book Page 15 Friday, May 27, 2005 3:53 PM

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 105 106

Sin comentarios

EMC Qlogic QLA22xx Guía de instalación Pagina 89