EMC Qlogic QLA22xx Guía de instalación descargar pdf (Pagina 47)

Configuring a Symmetrix Boot Device

3-11

Configuring an EMC Boot Device

5. Frame Size = 2048 (default)

6. Select the topology for your configuration. In most cases, the

default setting will work for all configurations.

7. Data Rate = 2 (default)

Type 0 at the selection prompt to return to the main menu.

13. Next, we will ensure the HBA advanced settings are correct for

boot. Select menu choice 2 (edit_advanced_settings) at the

selection prompt and enter values for the following parameters:

1. Operation Mode = 0 (default)

2. Interrupt Delay Timer (dec) = 0 (default)

3. Execution Throttle (dec) = 256

4. Login Retry Count (dec) = 8 (default)

5. Port Down Retry Count (dec) = 45

6. Link Down Timeout (dec) = 0

7. Luns Per Target (dec) = 256

8. Enable Extended Logging = N (default)

9. Enable LIP Reset = N (default)

10. Enable LIP full login = Y (default)

11. Enable target reset = Y (default)

Type 0 at the selection prompt to return to the main menu.

14. After all the settings are correct, select menu choice 11 (write) at

the selection prompt to save them to the HBA.

15. After saving the changes, select menu choice 12 (quit) to exit the

EFI command line utility.

16. Reboot the server (reset at the Shell> prompt) to cause changes to

take effect.

At this point, the HBA is ready to boot from the assigned LUN. Your

fabric may not be configured with the correct zoning information to

allow the HBA to see the storage array. After the server boots up, you

will be able to view the WWN of the HBA in the fabric utility. From

there, you can configure your zone(s) on the fabric to allow the HBA

to connect to the array properly.

QLogic_Windows.book Page 11 Friday, May 27, 2005 3:53 PM

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 105 106

Sin comentarios

EMC Qlogic QLA22xx Guía de instalación Pagina 47