EMC Qlogic QLA22xx Guía de instalación descargar pdf (Pagina 44)

3-8

EMC Fibre Channel with QLogic HBAs in the Windows Environment

Configuring an EMC Boot Device

1. Type drivers at the EFI shell prompt to display the list of loaded

EFI drivers. You will see an entry (or entries) similar to the

following:

5D 0000011E B X X 1 HP 2 Gb Fibre Channel Driver PciRom Seg=00000000

5D 00000140 D X X 1 - Qlogic Fibre Channel Driver PciRom Seg=00000000

2. The first column (in this example, 5D) is the driver handle for the

HBA. To unload the EFI boot code driver, use the unload

command:

unload 5D

3. After all instances of the QLogic EFI boot code driver are

unloaded, proceed to the next section.

To flash the HBA with the latest EFI boot code, copy the files from the

EFI boot code package to a floppy disk. If your system does not have

a floppy drive, a USB pen drive can be used instead. If your system is

already booted to the EFI shell, insert the floppy or USB pen drive

and type

exit to exit the EFI shell. From the boot options menu,

select EFI Shell [Built-in] to go back into the EFI shell. This will

cause the EFI shell to re-discover disk devices and will locate the

floppy or pen drive.

When you enter the EFI shell, the device map should be displayed. If

it does not display, type

map at the shell> prompt to display the list

of detected devices. Disk devices that are accessible by the EFI shell

are listed as

FS devices. Switch to the device containing the EFI boot

code. This is accomplished by typing the name of the device and a

colon. For example, if the EFI boot code is on

fs1, type fs1: and

press

ENTER to switch to that device. If your HBA does not have EFI

boot code already installed, you must use the

EFIUTIL.EFI driver

utility in order to flash the board. At the command prompt, type

EFIUTIL and press ENTER. This will load the QLogic EFI utility and

display a efiutil> prompt. The following commands assume that the

EFI boot package files are all located in the same directory as the

EFIUTIL.EFI program.

1. To load the EFI driver onto the HBA, type ew and press

ENTER.

The driver image binary filename, by default, is

ql2312ef.bin.

The

EFIUTIL program will prompt for the filename, and pressing

ENTER selects the default. Confirm that the version being installed

is correct by typing

Y and pressing ENTER. The driver will begin

flashing to the HBA. The

efiutil> prompt will reappear when

the load is complete.

QLogic_Windows.book Page 8 Friday, May 27, 2005 3:53 PM

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 105 106

Comentarios a estos manuales

Sin comentarios

EMC Qlogic QLA22xx Guía de instalación Pagina 44

Comentarios a estos manuales

Relacionado con productos y manuales para Redes EMC Qlogic QLA22xx