EMC Qlogic QLA22xx Guía de instalación descargar pdf (Pagina 77)

Installing the HBA Driver

4-3

Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)

4. If Windows Plug-n-Play does not detect your QLA4010 HBA

model, it will be listed as Unknown or as a Network Controller

under the Other Devices icon in the right pane.

Windows 2000 configurations with Service Pack 4 or higher and

Windows 2003 configurations may be able to detect QLA4010

HBAs. If this occurs, the HBA will already be listed under SCSI

Devices; instead of proceeding with these installation steps,

follow the instructions under Updating the HBA Driver in a

Windows 2000 or Windows 2003 Host on page ?

5. Double-click the first instance of Unknown or Network

Controller under Other Devices.

6. In the next dialog, click ReInstall Driver, and then, click Next.

7. Select Display a list of the known drivers for this device so that

you can choose a specific driver, and then click Next.

8. Select SCSI and RAID Controllers, and then click Next.

9. Click Have Disk.

10. Enter the path to the diskette containing the driver (for example,

A:\), then click OK.

11. Select the appropriate QLogic HBA from the list of drivers that

appears; then click Next.

12. Click Next in the next dialog.

13. Click YES to continue the installation.

14. Click Finish to complete the driver installation.

15. The system requests that you reboot the system. Select No and

click Close.

16. The system again requests that you reboot the system. Select NO

again.

17. If other QLogic HBAs are installed, repeat steps 5 through 16 until

all adapters are installed.

18. Reboot the host.

QLogic_Windows.book Page 3 Friday, May 27, 2005 3:53 PM

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 105 106

Sin comentarios

EMC Qlogic QLA22xx Guía de instalación Pagina 77