EMC Qlogic QLA22xx Guía de instalación descargar pdf (Pagina 46)

3-10

EMC Fibre Channel with QLogic HBAs in the Windows Environment

Configuring an EMC Boot Device

3. The first two hex digits are the driver handle. To determine the

control number, type

drvcfg

and press ENTER. You will

see both the handle and control numbers displayed for that HBA:

Configurable Components

Drv[5D]Ctrl[60]Lang[eng]

4. To start the EFI command line utility, type drvcfg –s

and press ENTER. (for example, drvcfg –s 5d 60)

5. At the selection prompt, select menu choice 8 (info) and press

ENTER. This will display the HBA information, which includes the

world wide number of the HBA. Write the WWN down to aid in

fabric zoning.

6. At the selection prompt, select menu choice 3 (edit_database) and

press

ENTER.

7. At the Entry in WWN database to edit prompt, type 0.

8. At the Entry 0 Port WWN prompt, enter the 16 digit WWN of

your storage array boot port recorded earlier. Do not enter the

HBA WWN that was noted in step 5.

9. At the Node WWN prompt, retype the storage array WWN again.

10. At the LUN (hex) prompt, type the LUN number that you will be

booting from.

11. Once entered, the Entry in WWN database to edit prompt will

re-appear. This gives you the chance to configure a secondary

boot LUN. Repeat steps 7 through 10 for up to 4 alternate boot

LUNs. Simply type in the database number (1-4) to configure

them. If you are finished with configuring boot LUNs, press

ENTER at this prompt to return to the eficfg> prompt.

12. At this point, edit the HBA settings to make sure the topology

and other parameters are correct for boot. Select menu choice 1

(edit_adapter_settings) at the selection prompt and enter values

for the following parameters:

1. Enable Hard Loop Id? = Y (Note: Only necessary for

direct-connect configurations)

2. Hard Loop Id (hex) = 255 (Note: Only direct-connect

configurations also.)

3. Reset Delay (dec) = 5 (default)

4. Enable FC Tape = Y (default)

QLogic_Windows.book Page 10 Friday, May 27, 2005 3:53 PM

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 105 106

Comentarios a estos manuales

Sin comentarios

EMC Qlogic QLA22xx Guía de instalación Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Redes EMC Qlogic QLA22xx