EMC QLogic Guía de instalación descargar pdf (Pagina 43)

Uninstallation methods for the QLogic v8.xx.xx driver

Installing and Configuring the QLogic HBA and v8.x-Series Driver

Uninstallation methods for the QLogic v8.xx.xx driver

This section describes how to successfully uninstall the QLogic

v8.xx.xx driver from a Linux host.

The method used to uninstall the driver is dependent upon the

installation package:

◆ Method One - Using the QLogic DKMS RPM

◆ Method Two - Using the QLogic installation script

Uninstalling the QLogic v8.xx.xx driver via the QLogic DKMS RPM: Method 1

This section provides guidance for uninstalling the QLogic v8.xx.xx1

driver via the QLogic DKMS RPM package. The driver may be

removed from the system with the 'e' switch for the RPM command.

The following are example steps to uninstall the QLogic driver.

Please also refer to the README file in the driver package.

1. Verify the driver names by querying the DKMS RPMs.

[root@l82bi235 qla2x00-v8.xx.xx]# rpm -qa | grep dkms

qla2x00-v8.xx.xxdkms

dkms-2.0.0-1

2. Uninstall the QLogic driver RPM using the following command:

root@l82bi235 qla2x00-v8.xx.xx]# rpm -ev

qla2x00-v8.xx.xxdkms

An example of the console output reported by the driver RPM

removal is as follows:

3. Verify that the

/etc/modprobe.conf and

/etc/modprobe.conf.local files contain the information

necessary for the server to boot and that a new ramdisk has been

created.

4. Reboot the host.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

Sin comentarios

EMC QLogic Guía de instalación Pagina 43