EMC QLogic Guía de instalación descargar pdf (Pagina 17)

Configuring the BIOS settings

Installing and Configuring the QLogic HBA and v8.x-Series Driver

Configuring the BIOS settings

After the HBA is installed, follow these steps during system boot to

verify and configure HBA firmware settings.

To use SANsurfer or SANsurferCLI for this function refer to the

SANsurfer or SANsurferCLI documentation you have downloaded.

Refer to the EMC Support Matrix for required BIOS versions for

qualified HBAs.

Verifying the correct BIOS version

You can determine the BIOS version at boot time from the QLogic

banner or from the Fast!Util Options menu.

◆ From the banner — Boot the host and watch for the banner

(shown in the QLA2340 example below, with the ROM BIOS

version highlighted):

• If the banner displays the required version, continue to the

section “EMC recommended HBA BIOS settings” on page 20.

• If the banner does not display the required version, upgrade

the firmware as described under the “Upgrading the HBA

BIOS” on page 19; then proceed to “EMC recommended HBA

BIOS settings” on page 20.

◆ From the QLogic Fast!Util Options menu:

a. Boot the host. When the QLogic banner appears, press

CTRL-Q to enter Fast!Util.

b. Select Configuration Settings from the Fast!Util Options

menu.

c. Select Adapter Settings from the Configuration Settings

menu.

d. Under Adapter Settings, note the BIOS version:

Qlogic Corporation

QLA2312 PCI Fibre Channel ROM BIOS Version 1.42

Press <CTRL - Q> for Fast!UTIL

www.qlogic.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 75 76

Sin comentarios

EMC QLogic Guía de instalación Pagina 17