EMC QLogic Guía de instalación descargar pdf (Pagina 148)

146

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Third-Party Software

QLogic SANsurfer SANblade Manager

Note: Stratus ftServers are not supported using the QLogic SANsurfer

SANblade Manager Software or Agents.

EMC has approved the use of a specialized version of the QLogic

SANsurfer SANblade Manager for use with attached EMC

Symmetrix and CLARiiON storage arrays. Only the versions listed

below should be used; these versions are posted in the EMC section on

the QLogic website.

This Windows utility provides information on the installed QLogic

HBAs, driver versions, mapped targets, statistics, and configuration

settings. It also has a feature to update the HBA firmware/BIOS and

NVRAM. (You should obtain the latest EMC-approved

firmware/BIOS and NVRAM files from the QLogic website. Refer to

“Downloading latest QLogic drivers/firmware/BIOS files” on

page 16 for instructions.)

For information on the use and features of the QLogic SANsurfer

SANblade Manager utility, refer to the documentation posted with

this utility.

SANsurfer version history

SANsurfer versions include:

◆ 2.0.21 — Initial Release

Note: The SANsurfer software is not multipath-aware, and as such may

misreport HBA targets that are configured in multipath. This does not

affect the use of the tool; however, it will accurately report targets only on

ports that own an active LUN0.

◆ 2.0.25 — Added target persistent binding capability and display

correction for LUNs on non-owning SP. (This functionality is

supported by QLogic; all usage questions and support issues

should be directed to QLogic.)

Note: SANsurfer 2.0.25 cannot be used to upgrade to BIOS 1.4x. Until a

later SANsurfer is available, you will need to use the

procedure“Install/upgrade firmware and boot BIOS from DOS” on

page 25 to perform this upgrade.

1 2 ... 143 144 145 146 147 148 149 150

Sin comentarios

EMC QLogic Guía de instalación Pagina 148