EMC QLogic Guía de instalación descargar pdf (Pagina 130)

128

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Miscellaneous Planning and Procedures

Special instructions for the EMC CLARiiON CX200 series

This section contains the following information:

◆ “Set the HBA FC-AL loop ID” on page 128

◆ “Direct-connect dual-host clustering configurations” on page 130

Set the HBA FC-AL loop ID

While configuring a QLA234x HBA for Windows 2000 and

connection to CLARiiON CX200 series for direct-connect cluster

configurations, you must manually set the HBA FC-AL Loop ID.

Follow these steps to enable loop hard addressing and set the loop ID

on each HBA:

Perform this procedure on all nodes in the cluster connected to the CX200

series array.

1. Boot the Windows host; press Ctrl-Q when prompted to Press

<CTRL-Q> for Fast!UTIL. (This prompt appears with the QLogic

startup banner.)

2. After the Fast!UTIL program loads, the initial display depends on

whether there are multiple QLogic HBAs installed in the server:

• If there is only one QLogic HBA, the Fast!UTIL Options menu

appears.

• If there are multiple QLogic HBAs, a list of memory addresses

occupied by those HBAs appears.

Using the arrow keys, select the desired HBA and press

ENTER.

The Fast!UTIL Options menu appears.

3. Select Configuration Settings from the Fast!UTIL Options menu,

and press Enter.

4. Select Host Adapter Settings from the Configuration Settings

menu.

5. Select Adapter Hard Loop ID from the Host Adapter Settings

menu and press

ENTER until the value is Enabled.

6. Select Hard Loop ID and press Enter.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 149 150

Sin comentarios

EMC QLogic Guía de instalación Pagina 130